Suche

ETS Professional Feature Requests

Compatibility Mode

Jürgen Schobloch

5. März 2026 11:26

In the new ETS version 6.4.0, I can only open projects with plug-in devices in compatibility mode (32-bit). This can also be set permanently.

However, compared to normal mode (64-bit), my performance is limited, and new devices may not work properly.

I would prefer it if the program could process both without having to switch modes.

Regards, Jürgen

5

Kommentare

2 Kommentare

Bitte melden Sie sich an, um einen Kommentar zu hinterlassen.

Hrayr Dantziguian

21. April 2026 06:32
On top of the above problem, so as not to lose time at project sites while servicing previous ETS6 projects involving KNX Devices with plug-ins, a KNX Partner should be able to either click or to right-click the ETS6 icon, such that:

a. Clicking the ETS6 Icon will launch ETS6

b. Right-clicking the ETS6 Icon will provide the choice to directly launch ETS6 Compatibility mode
2
Torstein Christensen

2. November 2026 13:44
Alternatively, ETS should offer the choice at startup:

Normal mode (64-bit) or Compatibility mode (32-bit).

In Settings, the user could select the preferred startup behavior:

Always start in Normal mode (64-bit)

Always start in Compatibility mode (32-bit)

Ask at startup

This would be especially useful because ETS has a relatively long startup time. Having to close and restart ETS just to switch between Normal and Compatibility mode is unnecessarily time-consuming, particularly when working with both new and legacy projects.
1