Error: Connection closed by remote device
Good morning,
First of all, I replied to another topic, but I don't think it will get any reply because the topic is tagged as 'Answered', so I open a new one.
I had the following error when programming: 'Connection closed by remote device'. The interface I used was a Homelynk LSS100100 from Schneider Electric. I programmed 4 devices with no problem, then went back to my desk to make some changes and came back to program the rest of the devices, and at this moment I got the error: 'Connection closed by remote device'. The loading bar was not starting to turn green. I tried to use "Use reduced bus communication rate", the bar was almost half loaded, and the same error came out again.
In the end I tried with an MTN6502-0105 IP interface, and I was able to program the devices.
Have you been able to solve the problem in these two months? It's a very annoying problem, and I was lucky to have an additional interface available.
ETS version: 6.1.0 (build 5686)
Thank you for your help.
-
Hi Eneko,
I am having the same issue as you, but with a MTN670802 (only component which has the problem). I also use the LSS100100 as IP interface on ETS 6.1.0 (Build 5686).If you have any ideas on the issue it would be great, since I do not own another IP interface.
Thanks.0
Σχόλια
1 σχόλιο
Πραγματοποιήστε είσοδο για να αφήσετε ένα σχόλιο.