ETS6 Demo and KNX Virtual
When I used the ETS6 demo software to experiment with KNX Virtual, I found that the KNX Association products could not be added to the product catalog in the project. Why is this happening, thank you for your answer.
-
Are you able to find any solutions? Iam facing the same problem.
0 -
Please help on this matter...
0 -
I had a similar occurence when i was trying to add devices directly to the devices window. The adding would fail. I was able to get around that by adding the devices in the Topology window, to the TP area.
I think (although not sure) that when adding devices to the devices window the ETS tries to add them to the IP backbone. Yet the ETS Association devices needed for KNX Virtual experimentation are TP devices, which leads to some sort of conflict. When adding the devices in the Topology window and adding them explicitly to the TP Area, it worked for me.
0
Σχόλια
3 σχόλια
Πραγματοποιήστε είσοδο για να αφήσετε ένα σχόλιο.