unload_devices
Dear Team,
it is cool to find device with "programming mode", but what if I dont have device in project anymore - but still connected on bus ?
It will be very useful, if when I found device with "programming mode", press right click on mouse and unload it?
Or If I have device with no individual address (Parked)???
-
I understand your suggestion and the convenience it could bring but it would be risky.
If you find an unknown device it would be better to investigate further by adding a device to the project (even a Dummy) and use Device Info, Reconstruction App or similar to establish what device it is and also which group objects and addresses are in use. In a project where poor (or no) documentation is available it could be the case that an unknown device is crucial to some functions of the installation - e.g. a logic module.
Unloading a device in an installation without sufficient knowledge about that device could break some functionality in the project with no possibility to recover the original configuration.
0
Σχόλια
1 σχόλιο
Πραγματοποιήστε είσοδο για να αφήσετε ένα σχόλιο.