Consistent Product Order When Copying Rooms in ETS6

When copying a room in ETS6, the order of devices/products changes compared to the original room. This creates unnecessary confusion and reduces efficiency when working on larger projects.

It would be highly beneficial if the copied room retained the same product order as the original. For example, in the original room the order might be:

• Detector (lowest KNX address)
• Switch
• Climate actuator
• Damper actuator

After copying, this logical structure is lost.

The desired behavior is that the product order in the copied room should remain identical to the original, based on KNX individual addresses rather than the order in which the products were added to the room.

This would improve consistency, readability, and overall workflow—especially in projects with many rooms and devices.