Display of Group Range and Group Address in the same view
A bit of a feature suggestion, and steps to reproduce.
- Create a group range called "Group Range A".
- Under "Group Range A" create another group range called "Group Range B".
- Select "Group Range A" on the tree view on the left, and "Group Range B" is displayed on the right.
- Now under "Group Range A", create a group address called "Group Address A".
- Again select "Group Range A" on the tree view on the left, and you will find that "Group Range B" is no longer displayed on the right, only the group address, "Group Address A" is displayed.
It would be very useful to have the right hand pane sectioned up so that it displays the subordinate group ranges AND the subordinate group addresses to allow for quick editing of group ranges in the right hand pane.
1
-
A better solution might be as below.
Consider the Topology view when you select a device in the tree view on the left hand side. You get the two tabbed views on the right hand side, 'Parameter' and 'Group Objects'.
In the Group Address view, when you select a group range on the left hand side tree view, you should get two tabbed views on the right hand side, 'Group Addresses' and 'Group Ranges'.
1
Σχόλια
1 σχόλιο
Πραγματοποιήστε είσοδο για να αφήσετε ένα σχόλιο.