Manual setting of the programming status
Απαντημένη
There are some devices which can not be programmed (e.g. dummy device).
It would be cool to set the programming status manually. This gives you a clean and completely programmed project. Thereafter, no initial or modified device is left.
-2
-
Επίσημο σχόλιο
Hello Alexander, this feature exists for manufacturers in the Manufacturer Tool already. The fact that it's not used, it's not up to KNX Association.
Σχόλια
1 σχόλιο
Πραγματοποιήστε είσοδο για να αφήσετε ένα σχόλιο.