When the Admin is logged into the project, he has the possibility to grant access to specific device parameters to the End Customer. This could be very useful, if e.g. the Admin would like to allow the customer to modify the temperature setpoint from his bedroom's thermostat.
By default, all the parameters are visible to the End Customer when the project is released.
To do so, the Admin shall open the device parameters for which he wants to grant access and then tap the 'Permissions' button
Once done, the parameters page is grayed out, i.e. the page becomes inaccessible to the End Customer and the 'Permissions' button becomes green.
In order now the Admin to allow the End Customer to access this parameter page and therefore allow him to modify the temperature setpoints for the different operation modes, the Admin has to tap each parameter separately.
When the Admin finishes his work and delivers the project to the End Customer, then the only visible elements of that device configuration to the End Customer will be the following: