BCU2 (native) – KNX Association

(Native) BCU2 application programs are those assigned to mask versions x02xh with LoadProcedureStyle = ProductProcedure.

Restrictions

The following restrictions apply for native BCU2 application programs without Hawk plugin:

·The ProgramType must be "ApplicationProgram" (not "PeiProgram")

·The AddressTable must start at address 0116h

·If DynamicTableManagement is set, the Association table must be directly after the address table.
If the segment allocation for the address table in the load procedure specifies CRC protection, the association table will by allocated after the CRC byte following the address table segment.

Additional tasks

Check PID_HARDWARE_TYPE (mask version 0025h only)