This view lists all devices offered by KNX Virtual, 23 in total.
this LED indicates activity via the IP/TP interface (D20)
represents telegrams exchanged between ETS and KNX Virtual
the LED indicates activity via the IP/TP coupler (D19)
represents telegrams exchanged between a physical KNX installation and KNX Virtual
The individual address of the IP/TP interface is set to 1.1.255 and cannot be changed
The devices are divided over two lines: line 1.0 and line 1.1
These lines addresses cannot be changed
The dimming actuator (D0), the blinds actuator (D2) and the switching actuator (D7) can be moved from line 1.0 to line 1.1 and vice versa:
by using the check box 'move device to the other line and/or clear all device settings'
this will also clear all settings of all devices
The IP/TP coupler (D19) is put in line 1.0 and cannot be moved
All other devices are put in line 1.1 and cannot be moved
Device labels and programming buttons:
The labels on the borders e.g. 'D7' in the device indicate the device number, this corresponds with the label of the device indicated between brackets in the Application Program in ETS, e.g. 'Switching Actuator (D7)'.
Any device can be put in programming mode by clicking its programming button. For a device in programming mode this button is lit red.
The only exception is the IP/TP interface (D20), this programming button is not active - i.e. it does not lit red - because the individual address of this device shall not be changed.
The inside labels indicate the currently set Individual Address
for the IP/TP interface (D20) this is indicated in red
Note: this is the ONLY view offering access to the programming buttons