ETS - Error (The system does not have enough memory to process this command...)
Con rispostaDear Team Support,
I have running with this error on ETS several times when working on ETS.
ETS - Error
The system does not have enough memory to process this command. Please try to split the operation into smaller steps. The ETS will close now.
After this error the ETS closes and I have to open it again (sometimes I lost progress changes on the project).
This errors occurs when I restore more than 3 projects from backup archive, but some times I can restore more than 3, sometimes less.
When I have more than 1 ETS project open and switch from tabs or open local projects, etc, sometimes this error also occurs.
I have more people in our team that this errors occurs.
Can you somehow check if this is a problem with the software, because the ETS closing without a reason it's having a lot of impact on our workflow.
Thank You
Kévin Simões
-
Commento ufficiale
Hello Kévin, I have created a support ticket out of this request so that we can handle it with our developers. Let's continue the discussion there.
Regards, Vassilios
-
I get also this error sometimes. But with this error the ETS does not crash.
0 -
Is there an update on the cause of this issue. I'm running into the same thing and cannot start ETS anymore.
However with me it occurs when just starting ETS6 immediately after opening the app with the shortcut
-1 -
KNX support suggested that to overcome the problem in question, I should disable Compatibility Mode.
However, I still have the problem of ETS6 closing due to lack of memory.
One time it happened to me with ETS6 open and I hadn't performed any operations on ETS6.
At this moment I cannot operate the ETS6 as normally as I did before.
0
Commenti
4 commenti
Accedi per aggiungere un commento.