Download individual address using serial number of the device
Pianificato
Hi
A lot of manufacturers provide labels with serial numbers of the devices.
These labels you put on the device, on the floor plan, on a list,...
With these serial numbers you can download the individual address of the device without pressing the programming button.
It's very easy if the installer and the integrator is not the same person.
It would be great if this could be done in ETS without the need of a separate ETS app.
The app Address by ID doesn't work well in ETS6, the individual address is loaded, but the download flag stays low.
-
Hi
Update: The app 'Address by ID' now works well in ETS.
The 'ADDR' download flag goes high after download.
Unfortunately, you need to activate compatibility mode to be able to use the app.@KNX Association
I was informed downloading the individual address based on the serial number would be implemented natively in ETS.
Without the need of an app or a license or compatibility mode.
I know for sure this will decrease the commissioning time of a KNX installation.
How far are you with the development?Kind regards
0
Commenti
1 commento
Accedi per aggiungere un commento.