Compatibility Mode
In the new ETS version 6.4.0, I can only open projects with plug-in devices in compatibility mode (32-bit). This can also be set permanently.
However, compared to normal mode (64-bit), my performance is limited, and new devices may not work properly.
I would prefer it if the program could process both without having to switch modes.
Regards, Jürgen
3
-
On top of the above problem, so as not to lose time at project sites while servicing previous ETS6 projects involving KNX Devices with plug-ins, a KNX Partner should be able to either click or to right-click the ETS6 icon, such that:
a. Clicking the ETS6 Icon will launch ETS6
b. Right-clicking the ETS6 Icon will provide the choice to directly launch ETS6 Compatibility mode
0
コメント
1件のコメント
サインインしてコメントを残してください。