Interface Check: interface address does not correspond to any line in your project.

When I try to download a setting I get the following error message.
This is only recently since a couple of months ago it worked normally.

I checked the message board and someone suggested to set the 1.1 TP line to "None"  in the bus connection, but I can't find the bus connection.

When I mention to "keep current settings" he mentions that I should press the "program button" of the device and then he downloads the settings fine. But I have to keep pressing the "program button"  of the device every time.

I do see the following messages. But I didn't do this myself.

Kind regards,

Ben