Design KNX USB Interface
Beantwoord
Hello Dears.
i am electronic engineer that deciding to design KNX USB Interface board .
all thing is right but there is one problem. i can't found any document for protocol of data transfer over USB between Board MCU and ETS, is there any source code example or firmware for it???
0
-
Officiële opmerking
Hello Vahid,
Thanks for your question. I have created a support ticket so that my colleagues can help you further with your request.
Best regards,
Vassilios
Opmerkingen
1 opmerking
Post is afgesloten voor opmerkingen.