Error: Connection closed by remote device

Good morning,

First of all, I replied to another topic, but I don't think it will get any reply because the topic  is tagged as 'Answered', so I open a new one.

I had the following error when programming:  'Connection closed by remote device'. The interface I used was a Homelynk LSS100100 from Schneider Electric. I programmed 4 devices with no problem, then went back to my desk to make some changes and came back to program the rest of the devices, and at this moment I got the error: 'Connection closed by remote device'. The loading bar was not starting to turn green. I tried to use "Use reduced bus communication rate", the bar was almost half loaded, and the same error came out again.

In the end I tried with an MTN6502-0105 IP interface, and I was able to program the devices.

Have you been able to solve the problem in these two months? It's a very annoying problem, and I was lucky to have an additional interface available.

ETS version: 6.1.0 (build 5686)

Thank you for your help.