Copy Extended associations
When copying a motion sensor with Copy Extended the generated Group Addresses are associated on channel level instead of device level. It would be nice if we could change this.
Example current situation:
Sens1 output1 0/0/1
Sens2 output1 0/0/2
Sens1 output 2 0/0/3
Sens2 output2 0/0/4
Preferred:
Sens1 output1 0/0/1
Sens1 output2 0/0/2
Sens2 output1 0/0/3
Sens2 output2 0/0/4
1
-
Correct, have the same issue since the last Patch.
It was different on the versions before
0
Yorumlar
1 yorum
Yorum yazmak için lütfen oturum açın.