Skip to main content


Community Basics

ETS - Error (The system does not have enough memory to process this command...)




Please sign in to leave a comment.

  • Official comment
    Vassilios Lourdas

    Hello Kévin, I have created a support ticket out of this request so that we can handle it with our developers. Let's continue the discussion there.

    Regards, Vassilios

  • Kévin Simões

    I get also this error sometimes. But with this error the ETS does not crash.

  • Voornaam Achternaam

    Is there an update on the cause of this issue. I'm running into the same thing and cannot start ETS anymore.

    However with me it occurs when just starting ETS6 immediately after opening the app with the shortcut


  • Kévin Simões

    KNX support suggested that to overcome the problem in question, I should disable Compatibility Mode.

    However, I still have the problem of ETS6 closing due to lack of memory.

    One time it happened to me with ETS6 open and I hadn't performed any operations on ETS6.

    At this moment I cannot operate the ETS6 as normally as I did before.