Rooms and Cabinet

The software simulates 2 rooms and 1 Cabinet:

Cabinet

Contains:

• 1 switching actuator
• 1 dimming actuator
• 1 blinds actuator
• 1 valve actuator
• 1 binary input device (reed contacts)
• 1 movement/presence detector
• 1 logic module

1. To add these devices to the ETS project, an order number is provided: click 'Programming' inside the device
2. To commission these devices, a serial number is provided: click 'Programming' inside the device
3. All devices except for the logic module, provide load simulation and wiring information: click the menu (3 dots) inside the device

Living Room

Contains:

• 2 6-fold push button devices
• 1 room thermostat device
• 1 window
  • which can be opened/closed
  • its reed contact is wired to the binary input in the cabinet
• 1 blinds
  • wired to the blinds/shutter actuator in the cabinet
• 1 shutter
  • wired to the blinds/shutter actuator in the cabinet
• presence sensor
  • wired to the presence/movement detector in the cabinet
• movement sensor
  • wired to the presence/movement detector in the cabinet
• 1 room status area
  • please note: this is not a device
  • indicates presence
  • indicates movement
  • indicates blinds position + slats angle
  • indicates shutter
  • indicates room temperature
    • automatically set to the outside temperature in case of an inactive heating/cooling
  • indicates room brightness
    • automatically set to the outside brightness in case both the blinds and the shutter are in position 0%

Kitchen

Contains:

• 1 6-fold push button device
• 1 room thermostat device
• 1 window
  • which can be opened/closed
  • its reed contact is wired to the binary input in the cabinet
• 1 blinds
  • wired to the blinds/shutter actuator in the cabinet
• 1 shutter
  • wired to the blinds/shutter actuator in the cabinet
• presence sensor
  • wired to the presence/movement detector in the cabinet
• movement sensor
  • wired to the presence/movement detector in the cabinet
• 1 room status area
  • please note: this is not a device
  • indicates presence
  • indicates movement
  • indicates blinds position + slats angle
  • indicates shutter
  • indicates room temperature
    • automatically set to the outside temperature in case of an inactive heating/cooling
  • indicates room brightness
    • automatically set to the outside brightness in case both the blinds and the shutter are in position 0%

1. To add these devices to the ETS project, an order number is provided: click the 'i' symbol in the upper right corner of the device
2. To commission these devices, a serial number is provides: click the 'i' symbol in the upper right corner of the device
3. To see the full status of the room click the '#' symbol in the upper right corner of the room status area