Details (Detailed)

Defines the language setting for the textual parameters of all devices in a project. See also 'Languages' under general settings.

• Default is the Windows system language: This is the codepage of the underlying operating system of the computer where the download will be performed. The codepage can differ from that one where the project was originally created and later on exported (e.g. on another computer).
• Explicit selection of codepage: The codepage which is selected will be the one to be used, regardless of the project settings of computer where the download will be performed.

• Hide extended Group Address range for plug-ins (for more details see here)
  • this setting is by default enabled and has the purpose to avoid possible incompatibility issues with ETS3 plug-ins
  • if set:
    • ETS3 plug-ins cannot use the full Group Address range
    • i.e. in the 3-level representation this range is limited to: 0/0/1 … 15/7/255
  • if not set:
    • ETS3 plug-ins can use the full Group Address range
    • i.e. in the 3-level representation this means: 0/0/1 … 31/7/255

• Use low bus communication rate
  • if set:
    • all devices of the project will be programmed with standard frames (also the devices supporting long frames)
    • telegram throttling is enabled, which means that ETS will send out telegrams at a lower pace, i.e. a 150 ms delay between two telegrams will be used, this in order to support first generation products properly
  • if not set:
    • devices supporting extended frames will be programmed with extended frames, devices not supporting long frames will be programmed with standard frames
    • telegram throttling is not enabled, which means that ETS will send out telegrams without delay between two telegrams