Equipment Basic course
Please note that this equipment is also the same equipment as for the Condensed Practical Basic course/Refresher course.
The following product types shall be available in each training rig:
- Switch actuator
- Dimming actuator
- Shutter actuator
- The above products can be replaced by a multifunction actuator, e.g., a switch/shutter actuator or dim/switch actuator, etc.
- Sensors with functions to 'switch', 'relative dimming,' and 'drive control (shutter)'
- Line coupler
- IP router (optional)
- Power supply
- 1 KNX RF S-Mode sensor and 1 KNX TP/RF media coupler:
- This set only has to be installed on one training rig, preferably on the training rig of the tutor.
- This set is only required for training centres that are located in a country in which the use of the 868 MHz frequency is allowed.
Please note that each training rig must include:
- At least one Secure sensor (TP or RF)
- At least one Secure actuator (TP or RF)
| Example of a mobile KNX training rig | Example of a fixed KNX training rig |