A KNX certified training centre can update the KNX devices and training rigs registered in its MyKNX profile at any time.
To update the training equipment, go to:
Account → Applications → Update your KNX training centre profile
Updating KNX devices
Under the equipment section of the training centre profile, you can:
- add new KNX devices; or
- remove KNX devices that are no longer used on the training rigs.
When adding or replacing equipment, make sure that the training rigs continue to comply with the applicable equipment requirements for all KNX course types offered by the training centre.
For more information, see:
- Equipment for the KNX Basic course
- Equipment for the KNX Advanced course
- Equipment for the KNX HVAC Specialist course
- Equipment for the KNX Energy Management course
- Equipment for the KNX Tutor course
Updating the number of training rigs
The number of fixed or mobile training rigs can also be updated in the training centre profile.
When adding a new training rig, the KNX devices installed on that training rig shall also be registered in MyKNX.
Training centres shall continue to comply with the minimum requirements concerning the number, ownership, and use of training rigs.
For more information, see General training rig requirements.
Registering equipment in MyKNX
For information about registering individual KNX products and the different product certification statuses displayed in MyKNX, see Registering training equipment in MyKNX.