The object “Operating hours - DPT_LongDeltaTimeSec (13.100, V32; s)” is typically used in KNX for recording the number of hours, e.g. a certain switch of a KNX actuator has remained in the ON position. By simple internal conversion mechanisms, it is possible to display the value in seconds, in hours or minutes.
It is also allowed to implement DPT_LongTimePeriod_nnn (12.10n, U32) but only if also DPT_LongDeltaTimeSec (13.100) is implemented. Also, note that the default parameter setting in ETS should always be set to DPT_LongDeltaTimeSec (13.100).
Object 'Operating hours'
